Instructions for use Isolette 8000 plus SW 5.n 63
Getting started
7.2 Functional check procedure
Perform the functional check procedure before the incubator is first placed into
service and after any disassembly for cleaning or maintenance.
WARNING
Risk of death or serious injury
A malfunctioning incubator may not provide therapy as set.
► Do not use the incubator if it fails to function as described in the functional check
procedure.
► Refer service to qualified personnel.
CAUTION
Risk due to faulty products
Signs of wear, e.g., cracks, deformation, or peeling, may occur with reprocessed
products.
► Check the products for signs of wear, pronounced hardening, and residual
soiling, and replace them if necessary.
For devices equipped with accessories and optional components, remove any
items that interfere with the functional check procedure, and replace when
completed.
7.2.1 Controller functional check
WARNING
Risk of fire
Missing or inadequate grounding can cause death or serious injury.
► To ensure grounding reliability, plug the power cable only into a properly
grounded 3-wire hospital-grade or hospital-use outlet.
► Do not use extension cables or extra outlets with multiple sockets.
► If any doubt exists as to the grounding connection, do not operate the
equipment.
CAUTION
Risk of injury or damage to the device
The device may not operate correctly with incompatible power.
► Make sure that the building power source is compatible with the electrical
specifications shown on the height adjustment trolley or on the incubator.
1 Perform the initial power-up procedures (see System start-up on page 61).
The incubator is powered on for at least 1 minute.
2 Check the Power Failure alarm:
The incubator must be powered on for at least 1 minute before this test is
performed.
To Next Page
Loading...
