EasyManua.ls Logo

DRAGFLOW EL7.5 - Manufacturers Warranty; Warranty Conditions

DRAGFLOW EL7.5
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 37121 VERONA Italy
Sede amm.: Via Paesa 46048 ROVERBELLA (MN) Italy Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 12/70
1.4 Manufacturer's warranty
The manufacturer guarantees the original user that the machine will be reasonably free
from factory and material defects.
In case of unpredictable defects, the user can claim the warranty.
Any warranty request must be recognized by the manufacturer as being subject to the
warranty conditions after presentation of adequate proof of claim, and eventually
accepted in one of the following ways, at the discretion of the manufacturer:
- replacement of defective part with a new one, made available in the offices of the
purchaser at the lowest transport rate;
- repair of defective part, after this has been returned to the manufacturer with
transport expenses prepaid.
In the first case, as soon as the new spare is ready, the user will make the defective part
available to the manufacturer workshop for inspection.
The manufacturer declines all responsability for the expenses due to “down time”,
business costs and losses deriving from faults and failure, even if under warranty
conditions.
Any claim for warrantable failures shall be sent in writing to the manufacturer prior to
the expiry of the warranty period.
This warranty is the sole warranty provided by the manufacturer.
There are no other warranties, explicit or implied, provided by the manufacturer.
1.4.1 Warranty conditions
The warranty does not apply to those parts that result defective because of incorrect
use and handling or bad observance of the use and maintenance instructions supplied
by the manufacturer.
The warranty completely expires as soon as non genuine spare parts are installed on the
equipment without the manufacturer permission.
The warranty on the electric motor and other warrantable components damaged due
to electric faults is applied only if the power supplying devices installed (power
generator, power cable, electric/control panel) are supplied by the manufacturer and
are specifically suitable for the present machine.
If the user tries, either to repair by his own any fault that is under guarantee or to use
spare parts not supplied directly by the manufacturer without his previous written
consent, the latter will not be responsible for the results of the repair and will not be
held to reimburse the expenses sustained by the user.

Table of Contents