DRAGFLOW EL7.5 - General Informations; Who Is the Manual Intended for

DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 8/70
1.2 General informations
This manual should be carefully consulted and understood because it contains
important information for the safety of operators during the machine use.
In case of doubt or uncertainty on the information provided in this manual please
contact the manufacturer for clarifiction.
However, the machine is intended suitable for uses which is expressly designed for,
produced and placed on the market. Any different use must be considered inappropriate
and therefore unsafety.
Any contractual or non-contractual liability of the manufacturer shall be excluded for
failures and damages caused by errors in the handling and use of the equipment not
compling with the instructions given by the manufacturer.
The manual translations from the original language (italian), may be inaccurate or
express unintentionally different concepts, therefore refer to the version in the original
language or contact the manufacturer for any clarification.
1.2.1 Who is the manual intended for
This manual must be read by any operator in charge of installing and using the
machine for the intended purposes it was designed, produced and placed on the
market.
The operator wording refers to a person without a specific skill, but able to perform
safetely the following activities:
- handling of loads (also suspended) with lifting devices such as fork lift or hoist;
- mechanical operation such as simple assembling and adjusting;
- cables wiring for disconnected electrical devices;
- machines using with commands and controls on electric panel and suitably
described by labels;
- machines using when they are in safety condition with all the provided safety
devides in perfect condition, properly installed and completely operative.
The operator must also have basic general culture and technical basic culture to
sufficiently read and understand the contents of the manual, including the correct
interpretation of images, drawings and pictograms.
It is the responsibility of the user of the machine to ensure the listed operator
requirements and to be trained about the health and safety standards in force in the
country where the machine is working.