DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 18/70
However, the best approach to avoid risks and prevent the damages is to use the
equipment exclusively for the intended use with expertise and caution.
Remember the followings:
- read with care and completely the present manual and the annexes, if present;
- don't hesitate to contact the Service Department of the manufacturer in case of
doubt or need;
- before every use, check carefully the integrity of the equipment and all its
components, with care for safety and lifting equipment.
2.3.1 Operating areas and safety
The operating area for the operator of the machine is close to the control panel.
During working operation, the machine is placed underwater and the operator must
stay in the defined operating area. No one must remains close to the dredging area.
The control panel must be placed in a dry and clean position. Take care that the
control panel is closed and every access inside it is denied without shutting down the
electric power.
During maintenance operation, the machine could be placed out of water. In this
occasion, operate on the machine only with the electric power shut down.
During maintenance operation, starting the machine out of water could be required.
In this occasion, any person must stay at a safety distance from the machine (not less
than 2 meters) in a dry and clean place. Before starting in this condition, check that
the machine is clean, specially its rotating components.
To Next Page
Loading...