DRAGFLOW EL7.5 - Water Sensor; Cooling Jacket; Cutter Knife; Spare Parts

DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 67/70
7.4 Water sensor
Not available
7.5 Cooling jacket
Not available
7.6 Cutter knife
The cutter knife is a optional device installed on the main shaft and replacing the
connector. Its purpose is to cut and minimize the dimension of some kind of solids
(tipically soft/fibrous wood pieces, seaweed and similar).
7.6.1 Spare parts
Fig. 44
POS.
Q.TY
PART NUMBER
DESCRIPTION
REPLACE POS./NR.
6A1
1
F39201 (*)
CUTTER KNIFE
11 / F21204