DRAGFLOW EL7.5 - Service Department; How to Read the Manual; Numbering of Figures and Labels; Service Manual

DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 14/70
1.5 Service Department
For any inconvenient or technical request, please contact the manufacturer Service
Department on:
tel.+39 0376 1685400
fax +39 0376 1685499
To locate a specific component of the equipment please refer to the diagrams and the
exploded views contained in this manual.
Always refer to the sections of the manual dedicated to the use and maintenance.
Contact the Service Department if it is not possible to solve the problem on site by your
own.
1.6 How to read the manual
For a correct reading and consultation, this documentation has been conveniently
divided into chapters. They are listed in the general index.
Some picture may not represent exactly the equipment with differences that anyway
don’t affect the accuracy of the given information.
1.6.1 Numbering of figures and labels
Each figure and table included in the manual is numbered in a progressive manner,
chapter by chapter.
Any label inside the figures could be a number, only when referred directly to a
position of the pump parts list, or letter.
1.7 Service manual
This manual provides instructions for the use and the basic maintenance of the machine,
concerning activities normally achievable in a generic environment.
Any other maintemance activities require to be performed in a workshop. In this case,
refer to the Service Department or to the Service Manual (available on request) for
assistance and instructions.