DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 13/70
1.4.2 Warranty exclusions
The warranty is not applied for the following listed parts subject to usual wearing:
- gaskets and sealing components;
- shaft sleeves;
- impeller kit;
- agitator kit;
- upper/lower wear plates;
- casing;
- strainer
- discharge adapter;
- any other component directly in contact with the dredge material flow.
The warranty is not applicable to the following electric components:
- power cables (when supplied);
- terminal board.
The warranty is not applicable to any consequential damage due to the failure under
warranty claim.
1.4.3 Warranty duration
The warranty lasts for 1 year from the delivery date specified in the contract.
If the contract condition foresees the machine start-up performed by a manufacturer
techinician, the duration of guarantee is 12 months from the start-up date and in any
case not over 16 months from the delivery date specified in the contract.
To Next Page
Loading...