DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 51/70
5.4.6 Motor bearing
Call the Service Department or see the Service Manual.
5.4.7 Lower seals
Call the Service Department or see the Service Manual.
5.4.8 Mechanical seals
Call the Service Department or see the Service Manual.
5.4.9 Upper bearings
Call the Service Department or see the Service Manual.
5.4.10 O-ring replacing
It’s good practice to replace any O-ring disassembled during maintenance operation,
even if it seems in good conditions.
When a O-ring must be replaced, lubricate it and carefully clean its seat before
positioning.
To Next Page
Loading...