DRAGFLOW EL7.5 - Before Every Shift; After Every Shift; During Every Shift

DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 36/70
5.2.1 Before every shift
Activity
Eventually…
Check for the good conditions of the power
cable and its inlet waterproofing components.
See the section Power cable in
the Service Manual or call the
Service Department.
Check for any anomalous noise or vibration by
starting the pump out of the water for no more
than 10 seconds.
Contact the Service Department
for more in-depth analysis.
Check for the good functionality of the
Emergency Stop button on the control panel.
Replace it before starting any
working operation.
Check for the good conditions of the lifting
points and lifting equipment used for the pump
moving.
Replace them before starting any
working operation.
Tab. 5
5.2.2 After every shift
Activity
Eventually…
Check for the cleaning condition of the inlet
zone of the pump.
Remove any object or material
clogging the strainer and the
suction area of the pump.
Wash the external surfaces of the pump with
clean water.
-
Tab. 6
5.2.3 During every shift
Activity
Eventually…
Check for the good performance of the pump
(typically working amperage and slurry
production).
See the sections:
- Impeller clearence checking
- Impeller clearence adjusting
- Agitator kit
- Impeller
in this manual.
Maintain clean end dry the control panel and
the operator working area.
-
Tab. 7