16
Connecting Voltage Measurement Cables
Measurement
Cable Set
Interconnect
Jumpers
Description: Voltage measurement cables are
provided as standard accessories, and are stored in a
cable pouch as part of the measurement cable set,
P/N VSC-HDPQ. Each cable set consists of a cable
and an alligator clip.
Voltage Rating: Direct connection of all voltage
measurement cables are rated at 1000 VCAT III Vrms
max. For measuring voltages greater than 1000 Vrms,
potential transformers (PTs) must be used.
The standard cable set for the HDPQ includes four (4)
interconnect jumpers bearing part number 114013-
G1. These interconnect jumpers can be used to
connect the same conductor points together and are
rated 600V CAT III. When using the interconnect
jumpers, also use the supplied wire markers to identify
the wiring connections applicable to your installation.
WARNINGS
DO NOT EXCEED 600 VRMS when using Dranetz
P/N 114013-G1 interconnect jumpers.
For circuit configurations above 600VRMS, each
voltage channel input is to be individually connected
to the HDPQ instrument with the supplied 1000V CAT
III cables and safety clips ONLY.
Optional Fused
Voltage Adapter
There are two optional fuse voltage adapter accessory
kits available for use with the measurement cables for
the HDPQ Xplorer. A single kit (P/N FVA-1K1)
contains one (1) fuse voltage adapter and one (1)
black measurement connecting cable 50 cm in length.
The other kit (P/N FVA-1K4) contains four (4) fuse
voltage adapters and four (4) black measurement
connecting cables 50 cm in length. These fuse voltage
adapters are rated up to 1000V AC/DC applications.
A wire marker kit consisting of snap-on wire markers
in various colors are also supplied with each fuse
voltage adapter to be used for identifying connections
applicable to your installation.
To Next Page
Loading...
Need help?
General
