38
Exit Setup
At the end of the Wizard Setup, the Exit Setup screen prompts you to
either accept the setup changes or not, before going on to start
monitoring (if accepted). You also have the option to use the instrument
as a meter, where monitoring setup changes are retained without turning
monitoring on.
If you jump to the Start Monitor mode while stepping through the Wizard
Setup, this screen will pop up to verify if the changes are to be accepted
or not, before continuing on to start monitoring (if accepted).
Use as Meter if you want to finish the setup process (save setup
changes) but DO NOT turn monitoring on.
Accept if you want to confirm changes made in monitoring settings
and start monitoring.
Exit if you want to retain monitoring settings as they were and return
to Start Menu.
Monitor Same Circuit
Menu options for monitoring become available only after setting up the
instrument or from reading a setup template from memory. You can
make use of existing setups for monitoring using the Monitor Same
Circuit key.