3-7
Chapter 3 Advanced Operation
2. Standard Folding of Non-Standard Paper
Standard folding of non-standard paper is a method to register the paper length of paper other than
standard paper, select the standard folding mode, and fold paper.
Paper other than the six standard paper is called non-standard paper. (The A6, A7, or B7 paper can be used
as non-standard paper.) (ve standard paper sizes For North America)
The foldable sizes are as follows. (width x length)
Width :
74 to 311 mm/
2.91 to 12.24 inches
Paper feed
direction
Paper
Length : 105 to 457.2 mm/
4.13 to 18.00 inches
Maximum : 311 x 457.2 mm/12.24 x 18.00 inches
Minimum :74 x 105 mm/2.91 x 4.13 inches
Depending on the paper length, the following
folding modes are limited.
Double fold
182 to 457.2 mm/7.16 to 18.00 inches
Irregular accordion fold-out
182 to 457.2 mm/7.16 to 18.00 inches
Letter fold
141 to 457.2 mm/5.55 to 18.00 inches
Accordion-fold
141 to 457.2 mm/5.55 to 18.00 inches
Gate fold
128 to 432.0 mm/5.03 to 17.00 inches
• Standard paper which is stacked on the paper feed tray in the long edge feeding direction is
considered non-standard paper.
• The paper sizes which can be used may vary with the paper type, thickness, and printing
state.
For standard folding, refer to Chapter 2 “3. Standard Folding of Standard Paper” (p.2-4).
Paper Size Set
Set
Auto
P Length
457.0
1
Press the menu key to display [Paper Size Set].
2
Press the key.
Setting can be changed at this stage.
Paper Size Set
Set
Man
P Length
457.0
3
Press the key or key to select [Man].
4
Press the key.
The selected details are set.
Paper Size Set
Set
Man
P Length
457.0
5
Press the key to select [P Length].
6
Press the key.
Setting can be changed at this stage.
To Next Page
Loading...
Need help?
General
