3-17
Chapter 3 Advanced Operation
4-1-3. Operation procedures
Do not touch the power switch
with wet hands.
Otherwise electric hazards may occur.
1
Turn on the power.
2
Set to single folding using the folding mode key.
3
Press the test key to test fold.
4
Check the nish.
• Store the cross fold lever at the original position
after cross fold operation.
• When the DF HAND FEED KIT is attached, the
location to store the cross fold lever will be changed.
(p.4-4)
Be sure to store the cross fold lever at
the specied place and in the specied
direction. By moving during operation
of this machine the folding roller may be
damaged, resulting in malfunction.
To Next Page
Loading...
Need help?
General
