Duplo DPB-500 - Page 121

To Next Page

To Previous Page

5-5

CHAPTER 5 CLEANING THE UNIT

Milling section

●

Remove the paper chips around the

milling section using the vacuum

cleaner.

Do not touch the blades while cleaning the milling section. Touching the blades may

cause injuries.

Clean this surface.

Rail

●

Clean the top of the rail.

Main Page

Default Chapter7
- Power Supply7
- Maintenance / Others9
- Hot Melt Glue10
- WARNING / CAUTION Labels11
- Table of Contents13
Chapter 1 BEFORE OPERATION15
Features16
Workﬂow17
Names and Functions18
- External Parts18
- Milling Section19
- Glue Tank Section20
- Nipping Section21
- Scoring Section22
- Feed Section23
- Delivery Section24
Screen Descriptions25
- Settings Screen for Binding25
- Fine-Adjustment Screen25
- Motion Check Screen26
- Option Setting Screen27
Accessories28
Precautions on Hot Melt Glue31
Cautions for Handling32
Emergency Stop33
Paper Size34
- Cover and Book Block Size34
- Book Block Thickness and Cover Weight34
- Using Single-Folded or Double-Folded Paper35
- Cover Type35
Chapter 2 PREPARING for OPERATION37
- Turning on the Power38
- Preparing Hot Melt Glue39
- Preparing each Section42
- Entering Job Information48
Chapter 3 STARTING BINDING OPERATION59
- Placing a Book Block60
- Test-Feeding a Cover64
- Starting Binding72
- Removing the Booklet75
- Adding Covers78
- Finishing Binding79
- Using Supplied Parts81
- Using Wing Scoring83
Chapter 4 FINE-ADJUSTMENT and OPTION SETTING87
Fine Adjusting each Part88
- Setting the Paper Feed Guide88
- Setting the Scoring Width90
- Adjusting the Nipper Guide91
- Setting the Nipper93
- Setting the Glue Cutting Position94
- Setting the Width of Side Glue95
- Adjusting Spine Glue Amount96
- Adjusting Side Glue Amount97
- Adjusting the Nipping Station98
Using Motion Check99
- Ejecting Jammed Paper99
- Discharging Booklet99
- Adjusting the Height of Paper Feed Tray100
- Moving the Clamp100
Setting the Options101
- Setting the Nipping Delay Time101
- Setting the Nipping Time101
- Setting the Clamp Speed102
- Setting the Glue Tank Temperature104
- Setting the Standby Mode104
- Setting the Heater Schedule105
- Setting the Auto Start ON/OFF107
- Setting the Hispeed ON/OFF108
- Setting the Receiving Tray ON/OFF109
- Setting the Feed Guide and Nipper Guide Synchronously110
- Setting the External Equipment ON/OFF111
- Setting the Contrast112
- Setting Opening Amount of Clamp (for Normal Mode)113
- Setting Opening Amount of Clamp (for Variable Mode)114
- Setting a Transparent Cover ON/OFF115
Chapter 5 CLEANING the UNIT117
- Cleaning each Section118
- Replacing Hot Melt Glue122
- Adjusting the Date and Time126
Chapter 6 TROUBLESHOOTING GUIDE127
- Solving Glue Problem128
- Troubleshooting132
- Error Messages138
Chapter 7 APPENDIX145
Speciﬁcation146

Duplo DPB-500 - Page 121

Table of Contents

Related product manuals