Duplo DPB-500 - 1. Powering On and Glue Preparation

2-2
CHAPTER 2 PREPARING FOR OPERATION
1. Turning On the Power
1.
Turn the power switch to the right to turn on the power of the machine.
OF F
Power switch
OF F
The hot melt glue in the glue tank will be ready for binding in about 30 minutes at earliest after you
turn on the power.
The time for the machine to be ready for a binding operation after turning on the power
varies depending on the hot melt glue you are using and the environment.
2.
Turn the panel angle adjustment knob to adjust the angle of the touch panel.
Touch panel
Panel angle
adjustment knob
3.
Tighten the panel angle adjustment knob to fasten the touch panel.