6-2
CHAPTER 6 TROUBLESHOOTING GUIDE
1.
Solving Glue Problem
The listed below is common problems related to applied glue. For other problems, refer to "2.
Troubleshooting."
A.
Adhesivity is weak.
Cause: The nipping time is not enough.
----> Chapter 4 "3-2. Setting the Nipping Time" (
p.4-15)
Cuase: The nipping delay time is too long.
----> Chapter 4 "3-1. Setting the Nipping Delay Time" (
p.4-15)
B.
The side glue width is different between the right and left sides (operator's side
and non-operator's sides) of a booklet.
Cuase: The side glue meter is not properly adjusted.
----> Chapter 4 "1-8. Adjusting Side Glue Amount" (
p.4-11)
To Next Page
Loading...
