Duplo DPB-500 - Page 14

viii
Safety Precautions
Chapter 4
FINE-ADJUSTMENT AND
OPTION SETTING
1. Fine adjusting Each Part ..................4-2
1-1. Setting the Paper Feed Guide ............... 4-2
1-2. Setting the Scoring Width ...................... 4-4
1-3. Adjusting the Nipper Guide ................... 4-5
1-4. Setting the Nipper ................................. 4-7
1-5. Setting the Glue Cutting Position .......... 4-8
1-6. Setting the Width of Side Glue .............. 4-9
1-7. Adjusting Spine Glue Amount ............. 4-10
1-8. Adjusting Side Glue Amount ............... 4-11
1-9 Adjusting the Nipping Station .............. 4-12
2. Using Motion Check .......................4-13
2-1. Ejecting Jammed Paper ...................... 4-13
2-2. Discharging Booklet ............................ 4-13
2-3. Adjusting the Height of Paper Feed
Tray ..................................................... 4-14
2-4. Moving the Clamp ...............................
4-14
3. Setting the Options .........................4-15
3-1. Setting the Nipping Delay Time ........... 4-15
3-2. Setting the Nipping Time ..................... 4-15
3-3. Setting the Clamp Speed .................... 4-16
3-4. Setting the Glue Tank Temperature ..... 4-18
3-5. Setting the Standby Mode ................... 4-18
3-6. Setting the Heater Schedule ............... 4-19
3-7. Setting the Auto Start ON/OFF ............ 4-21
3-8. Setting the Hispeed ON/OFF .............. 4-22
3-9. Setting the Receiving Tray ON/OFF .... 4-23
3-10. Setting the Feed Guide and Nipper
Guide Synchronously .......................... 4-24
3-11. Setting the External Equipment
ON/OFF ............................................... 4-25
3-12. Setting the Contrast ............................ 4-26
3-13. Setting Opening Amount of Clamp
(for Normal Mode) ............................... 4-27
3-14. Setting Opening Amount of Clamp
(for Variable Mode) .............................. 4-28
3-15. Setting a Transparent Cover
ON/OFF ............................................... 4-29
Chapter 5
CLEANING THE UNIT
1. Cleaning Each Section .....................5-2
1-1. Cleaning the Suction Belt ...................... 5-2
1-2. Cleaning the Level Plate .......................
5-3
1-3. Cleaning the Paper Path ....................... 5-4
2. Replacing Hot Melt Glue ..................5-6
3. Adjusting the Date and Time .............. 5-10
Chapter 6
TROUBLESHOOTING
GUIDE
1. Solving Glue Problem ......................6-2
2. Troubleshooting ................................6-6
2-1. Stacker Problem .................................... 6-6
2-2. Milling Problem ...................................... 6-6
2-3. Glue Problem ........................................ 6-7
2-4. Nipping Problem .................................... 6-8
2-5. Feeding Problem ................................... 6-9
2-6. Scoring Problem .................................. 6-10
2-7. Booklet Quality Problem ...................... 6-11
3. Error Messages ...............................6-12
3-1. Messages about Paper Jam ............... 6-12
3-2. Messages about External Cover ......... 6-13
3-3. Messages about Motor and Sensor .... 6-13
3-4. Other Messages .................................. 6-16
3-5. Other Error Codes ............................... 6-18
Chapter 7 APPENDIX
1. Specification .....................................7-2