1-15
CHAPTER 1 BEFORE OPERATION
No. Name Qty. Explanation
[4] Stabilizer Plate Lite Weight
Cover
1 Used when covers flaps fanned by separating air.
[5] Small Cover Guide 1 Attached to the suction part when feeding a small
cover.
[6] Small Cover Feed Belt
Accessory
1 Attached to the suction part when feeding a small
cover.
[7] Book Block Support Guide 1 Attached to the clamp when a book block is thin
and big to prevent it from bending over.
[8] Scale Label 1 Attach the label to the most suitable location
(sticker).
[9] Receiving Tray 1 Attached to the book exit when necessary. This is
attached to the machine at the factory.
[10] Knob Bolt 2 Used to attach the receiving tray to the book exit.
This is attached to the machine at the factory.
[11]
Instruction Manual 1 This manual
[12] Stacker Stopper 1 Attached to the book exit when necessary.
[13] Knob Screw 4 Used to attach the stacker stopper to the book
exit.
[14] Milling Adjustment Bar 1 Adjusts a milling depth.
[15] Wrench
(opposite side distance 3 mm)
1 Used to adjust the side glue meters and side glue
roller adjustment.
[16] Spanner 1 Used to adjust the side glue meters and side glue
roller adjustment.
To Next Page
Loading...
