Duplo DPB-500 User Manual

2-13
CHAPTER 2 PREPARING FOR OPERATION
Nipping
ON/OFF
button
Next Button
2.
Select whether to apply nipping to
the book block using the nipping ON/
OFF button.
Nipping (ON) Nipping (OFF)
When nipping is ON, the nipping station will
go up during operation.
Press the next button to go to "4-3. Setting
Book Block Size" ( p.2-16).
Press the cancel button to delete all the
settings you made so far and to go back to
the main menu.
● Before binding without a cover, wipe
the gray-colored part shown in the
figure using a cloth with silicon spray
applied. This will prevent hot melt
glue from adhering to the nipping
surface.
● When nipping is set to ON, short
nipping time may cause glue to
adhere to the nipping station. Check
the open time of the hot melt glue you
use and change the time if necessary
( p.3-15, 4-15).
Cancel Button
Next Button
Double Feed
Detection Button
3.
Turn ON or OFF the double feed
detection.
When set to ON, the double feed detection
button is displayed. Press this button to go
to "4-2. Setting Double Feed Detection for
Cover" ( p.2-14).
When set to OFF, press the next button to
go to "4-3. Setting Book Block Size"
( p.2-16).
Press the cancel button to delete all the
settings you made so far and to go back to
the main menu.

Duplo DPB-500 Specifications

General

Brand	Duplo
Model	DPB-500
Category	Binding Machine
Language	English