Setup
Operating Instructions 669 - 00.0 - 08/2019 101
6.13.8 Connecting the sewing light
Fig. 64: Connecting the sewing light
To connect the sewing light:
1. Loosen the screws on the front plate of the control unit.
2. Take off the front plate.
3. Push the cable from the rear through the cable duct (1) in the
control.
4. Take off the rubber guide track 2.
5. Use a screwdriver to punch though the circular opening in the
guide track.
6. Guide the cable for the sewing light transformer through this
new opening.
7. Replace the rubber guide track (2).
8. Use a thin screwdriver to press on the terminal openings (4)
and (3).
This opens up the terminals (5) and (6).
9. Connect the blue cable to terminal (6) and the brown cable
to terminal (5).
10. Re-attach the front plate using the screws.
(1) - Cable duct
(2) - Rubber guide track
(3) - Terminal opening
(4) - Terminal opening
(5) - Terminal
(6) - Terminal
To Next Page
Loading...
