DURKOPP ADLER 669 ECO - Setpoint Device for the Direct Drive; Assembling the Setpoint Device to the Stand MG 55-3 and Aligning the Pedal

Setup
Operating Instructions 669 - 00.0 - 08/2019 81
6.9 Setpoint device for the Direct drive
6.9.1 Assembling the setpoint device to the stand
MG 55-3 and aligning the pedal
Fig. 48: Assembling the setpoint device to the stand and aligning the
pedal
To assemble the setpoint device to the stand:
1. Screw the angle bracket (3) under the tabletop (4).
2. Screw the setpoint device (1) onto the angle bracket (3).
3. Hang the rod (2) on the setpoint device (1) and pedal.
To align the pedal:
1. Loosen screw on the rod (2).
2. Adjust the height of the pedal rod so that the released pedal
has a decline of about 10°.
3. Tighten the screw on the rod (2).
(1) - Setpoint device
(2) - Rod
(3) - Angle bracket
(4) - Tabletop
①
②
④
③