DURKOPP ADLER 669 ECO - Completing the Tabletop for Stand MG 56-3 with Direct Drive

Setup
Operating Instructions 669 - 00.0 - 08/2019 71
6.4.4 Completing the tabletop for stand MG 56-3 with
direct drive
Fig. 39: Completing the tabletop
To complete the tabletop:
1. Turn over the table plate (5)
2. Screw on the drawer (1).
3. Screw on the motor control (2).
4. Screw on the power supply (3).
5. Screw on flap trays (7) using two wood screws per tray.
6. Screw on the knee switch (4).
7. Screw on the sewing light transformer (6).
8. Screw on the cable duct (8).
(1) - Drawer
(2) - Motor control
(3) - Power supply
(4) - Knee switch
(5) - Tabletop
(6) - Sewing light transformator
(7) - Flap trays
(8) - Cable duct
⑤⑦④③ ②
⑦⑥ ⑧①
(5x25) x2 (4x20) x2 (3,5x17) x2
(3,5x17) x6
(5x25) x2 (4x20) x2