Setup
104 Operating Instructions 669 - 00.0 - 08/2019
Fig. 66: Setting the operating pressure
To set the operating pressure:
1. Pull the pressure controller (1) up.
2. Turn the pressure controller until the pressure gage (2)
indicates the proper setting:
• Increase pressure = turn clockwise
• Reduce pressure = turn counterclockwise
3. Push the pressure controller (1) down.
6.15 Performing a test run
When setup is complete, perform a test run to check the function-
ality of the machine.
(1) - Pressure controller (2) - Pressure gage
To Next Page
Loading...
