DURKOPP ADLER 669 ECO - Assembling the Direct Drive; Assembling the Motor and Putting on the V-Belt

Setup
Operating Instructions 669 - 00.0 - 08/2019 87
6.12 Assembling the Direct Drive
6.12.1 Assembling the motor and putting on the V-belt
Fig. 55: Assembling tho motor and putting on the V-belt
To assemble the motor and put on the V-belt:
1. Unscrew the handwheel (1).
2. Screw motor (4) onto the head using two screws (3) so that
it can be easily shifted.
3. Put on the V-belt (2).
4. Tighten the V-belt (2).
Press the motor (4) downwards and tighten both screws (3).
 When the V-belt has the correct tension, you should be able
to press down with your finger in the middle of the V-belt (2)
so that the V-belt (2) moves about 10 mm down.
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before assembling the
Direct Drive.
(1) - Handwheel
(2) - V-belt
(3) - Screws
(4) - Motor
①②③④