DURKOPP ADLER 669 ECO - Assembling the Setpoint Device to the Stand MG 56-3 and Aligning the Pedal

Setup
82 Operating Instructions 669 - 00.0 - 08/2019
6.9.2 Assembling the setpoint device to the stand
MG 56-3 and aligning the pedal
Fig. 49: Assembling the setpoint device to the stand and aligning the
pedal
To assemble the setpoint device to the stand:
1. Screw the setpoint device (3) onto the plate (5) on stand (1).
2. Hang the rod (2) on the setpoint device (3) and pedal.
To align the pedal:
1. Loosen screw on the rod (2).
2. Adjust the height of the pedal rod so that the released pedal
has a decline of about 10°.
3. Tighten the screw on the rod (2).
(1) - Stand
(2) - Rod
(3) - Setpoint device
(4) - Screws
(5) - Plate
⑤
④
②③①