Setup
Operating Instructions 669 - 00.0 - 08/2019 97
Connecting the DA321G control
Fig. 63: Connecting the DA321G control
To connect the DA321G control:
1. Plug the cable from the setpoint director device (pedal) into
the B80 socket on the control unit.
2. Plug the motor sensor cable (1) into the B2 socket on the
control.
3. Plug the motor cable (2) into the B41 socket on the control.
4. Plug the cable leading to the sewing machine into the A socket
on the control.
5. Route all cables through the cable duct.
6. Plug the cable from the operating panel into the B776 socket.
7. Plug the cable (3) from the knee switch into the KN19 socket
on the front side.
8. Use the clips (4) to fasten down the cable (3).
(1) - Motor sensor cable
(2) - Motor cable
(3) - Knee switch cable
(4) - Clips
To Next Page
Loading...
