3 Tests and Diagnostics
3-10
[CONFIDENTIAL] PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941)
Table 3-1 Subtest names (2/2)
TEST No TEST NAME SUBTEST No SUBTEST NAME
2 HDD/SSD Test 1
2
3
4
5
Sequential Read Test
Partial Read Test
Address Jump Test
Address Uniqueness Test
Specify Address Test
3 Keyboard Test
1
2
Key-Code Test
Touch Pad Test
4
LCD Panel Test
1
2
3
4
LCD Panel Test
All dot on / off Test
H - pattern Test
LCD brightness Test
5 Battery Charge
Test
-
6 Fan Test -
7 EXIT to TOP
Menu
After a subtest is selected, the following message may appear.
The meaning of each item is as follows;
Test Loop
Select No: After testing, the program returns to the screen to select Error Stop and Test Loop
item selection.
Select Yes: After testing, the pass count is increased by one, and the test is performed again
from the test top. Repeat the test until SHIFT + Q is entered.
The setting of Yes/No can be changed by pressing ENTER.
Error Stop
Select Yes: if any error occurs during the test, the test is suspended and key input is required.
To Next Page
Loading...
Need help?
General