dynabook PORTEGE X30W-J - Page 182

4 Replacement Procedures 4.9 FAN
4-40 [CONFIDENTIAL] PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941)
4.9 FAN
Removing the FAN
To remove the FAN, follow the steps below and refer to Figure 4-13.
1. Disconnect the FAN R HARNESS from the connector CN3380 on the SYSTEM
BOARD.
2. Remove the following screws and the FAN R.
 M24C S-THIN HEAD screw 2
3. Disconnect the FAN L HARNESS from the connector CN3390 on the SYSTEM
BOARD.
4. Remove the following screws and the FAN L.
 M24C S-THIN HEAD screw 2
NOTE: Do not touch the center portion of the FANs.
Figure 4-13 Removing the FAN
CN3380
M2x4C S-THIN HEAD
FAN R HARNESS
FAN R
(FAN1)
FAN L
(FAN2)
CN3390
FAN L HARNESS
M2x4C S-THIN HEAD