dynabook PORTEGE X30W-J - Page 183

4.9 FAN 4 Replacement Procedures
PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941) [CONFIDENTIAL] 4-41
Installing the FAN
To install the FAN, follow the steps below and refer to Figure 4-13.
4. Set the FAN R to the COVER ASSY and secure it with the following screws.
 M24C S-THIN HEAD screw 2
3. Connect the FAN R HARNESS to the connector CN3380 on the SYSTEM BOARD.
4. Set the FAN L to the COVER ASSY and secure it with the following screws.
 M24C S-THIN HEAD screw 2
4. Connect the FAN L HARNESS to the connector CN3390 on the SYSTEM BOARD.