dynabook PORTEGE X30W-J - Page 184

4 Replacement Procedures 4.10 SSD
4-42 [CONFIDENTIAL] PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941)
4.10 SSD
CAUTION: Take care not to press on the top or bottom of the SSD. Pressure may cause
data loss or damage to the device.
Removing the SSD
To remove the SSD, follow the steps below and refer to Figure 4-14.
1. Remove the following screw and disconnect the SSD from the connector CN1900 on
the SYSTEM BOARD.
 M22.5 FLAT HEAD DANTUKI screw 1
Figure 4-14 Removing the SSD
M2x2.5 FLAT HEAD DANTUKI
SSD
CN1900