dynabook PORTEGE X30W-J - Page 186

4 Replacement Procedures 4.11 HEAT SINK
4-44 [CONFIDENTIAL] PORTÉGÉ X30W-J, dynabook V*/VZ*/VC* Series Maintenance Manual (960-941)
4.11 HEAT SINK
Removing the HEAT SINK
To remove the HEAT SINK, follow the steps below and refer to Figure 4-15.
1. Remove the following screws and the HEAT SINK.
 M22.3C S-THIN HEAD screw 4
NOTE: When removing the HEAT SINK, be sure to remove the screws in the reverse
order of the number marked on the HEAT SINK.
Figure 4-15 Removing the HEAT SINK
M2x2.3C S-THIN HEAD
HEAT SINK
M2x2.3C S-THIN HEAD