Dynojet Dynoware RT - Computer System Requirements for Power Core

1-3
INTRODUCTION
Introduction
Version 5 DynoWare RT Upgrade for Model 424x Dynamometers Installation Guide
COMPUTER SPECIFICATIONS
You will need to provide a computer system to run the Power Core software. Refer to
www.dynojet.com for the latest computer requirements.
GROUNDING REQUIREMENTS
You will need to ground the vehicle to the dyno before every run using the vehicle
grounding kit P/N 76100015. Never operate the dyno without first grounding the vehicle
to the dyno. Refer to “Grounding the Vehicle” on page 4-9.
CAUTION
Never operate the dyno without properly grounding the vehicle to the
dyno.
description minimum specifications recommended specifications
Operating System Windows 7 or later Windows 7 or later
Processor Dual Core Processor, 
2GHz or faster
Intel Core i5 2.8GHz or faster
Memory 4GB System Ram 8GB System Ram or more
Hard Drive 100GB or larger
(54MB required for program)
500GB or larger
(54 MB required for program)
Monitor/Graphics Card 1280x1024 (SXGA) resolution or
higher
1600x900 resolution or higher
Network Adapter 1 free 10/100 Mbps
RJ45 Ethernet Port
1 free 100Mbps RJ45 Port or Wireless
External Media CD-Rom Drive CD-Rom Drive
Printer Printer, if prints are needed Color printer, if prints are needed