Dynojet Dynoware RT - Removing the Theta Controller-In Ground Dynos

3-7
MODEL 424 DYNOWARE RT UPGRADE WITH EDDY CURRENT BRAKE
Remove the DynoWare EX Electronics
Version 5 DynoWare RT Upgrade for Model 424x Dynamometers Installation Guide
REMOVING THE THETA CONTROLLER—IN GROUND DYNOS
Remove the theta controller from both the stationary and 4WD dyno.
1 Disconnect the power cable from the theta controller. Leave this cable in place.
2 Disconnect the controller cable from the theta controller. Leave this cable in place.
3 Disconnect the signal cable from the Breakout board and remove this cable from
the cable track. Refer to “Removing the DynoWare EX Cables” on page 3-19.
4 Remove the four screws securing the theta controller to the bracket and set aside.
5 Remove the theta controller.
Figure 3-3: Remove the Theta Controller—In Ground Dynos
AD635
theta controller
theta controller