32 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 13. Removing the Upper Side Panels
Right Upper Side Panel
FRONT
BACK
Left Upper Side Panel
3. Use a magnetized Phillips screwdriver to remove the trim on each side of the cabinet top panel (see
Figure 14 ):
• Remove and retain the four interior trim screws located on the inside of the side panel (A, B, C, and
D).
• Remove and retain the four pairs of outside trim screws located at the top on each rack (1 through 8).
• Remove and retain the top trim panels.
• Place both top trim panels and all mounting screws together in the same accessible location.
Top Entry Installation
To Next Page
Loading...
