42 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 24. BladeUPS Module Rear Panel
Load
(RPM) Connector
Breaker
Input
Breaker
Battery
Breaker
NOTE The load connector breaker controls the load connector only, not the output power cord.
2. Remove the UPS front cover and set it aside (see Figure 25 ).
Grasp the fingergrips on both sides of the cover and pull the cover forward firmly. Unplug the LCD cable
connecting the back of the control panel to the electronics module.
Figure 25. Removing the UPS Front Cover
Installing the Internal Batteries
To Next Page
Loading...
