44 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 28. Installing the UPS Single-string Battery Trays for 5.0 kVA BladeUPS
6. Reinstall the battery cover plate.
7. Install the UPS front cover (see Figure 29 ):
Plug the LCD cable from the control panel on the front cover into the connector on the electronics module.
Use care to loop the LCD cable gently in front of the electronics module.
Push the top of the front cover firmly into place, and then push the bottom firmly into place.
Figure 29. Installing the UPS Front Cover
8. For six UPS preassembled systems only. Repeat Steps 1 through 7 for UPS 6.
9. If installing optional EBM(s), continue to section 3.13 ‘EBM Installation” . Otherwise, continue to section
3.16 “Parallel System Initial Startup”.
Installing the Internal Batteries
To Next Page
Loading...
