98
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Shaft Disassembly/Assembly | Disassembly/Assembly TRSM0950
12. Slide the 5/32 OD air line up to align and hold washer
in place.
13. Install Reverse Gear with clutching teeth facing down.
14. Install and rotate the Selective Main Shaft Washer
(6.525, 6.712, or 6.900 mm) above Reverse Gear.
15. Slide the 5/32 OD air line up to align and hold washer
in place.
16. Install Main Shaft Key at the same spline as the 5/32
OD air line.
Note: Insert Main Shaft Key while removing air line.
To Next Page
Loading...
