112
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
2019.04.4
Main Housing Disassembly/Assembly | Disassembly/Assembly TRSM0950
9. Press Rear Lower Countershaft Bearing into Main
Housing until fully seated.
NOTICE: Support the Main Housing to avoid damaging
the housing and sealing surface.
NOTICE: Do not over press bearing into Main Housing.
Over pressing could result in component damage
and/or personal injury.
10. Verify Rear Lower Countershaft Bearing is fully seated
into housing.
11. Inspect Rear Upper Countershaft Bearing and verify
snap ring is fully seated in groove.
12. Place Rear Upper Countershaft Bearing into Main
Housing.
13. Place Countershaft Bearing Installer (RR1076TR) and
Universal Driver Handle (OE8044-T0) onto Rear Upper
Countershaft Bearing.
14. Press Rear Upper Countershaft Bearing into Main
Housing until fully seated.
NOTICE: Support the Main Housing to avoid damaging
the housing and sealing surface.
NOTICE: Do not over press bearing into Main Housing.
Over pressing could result in component damage
and/or personal injury.
To Next Page
Loading...
