2019.04.4
© 2018 Eaton Cummins Automated Transmission Technologies. All rights reserved
85
TRSM0950 Disassembly/Assembly | Input Shaft Pilot Bearing Wear Sleeve Disassembly/Assembly
5. Hold the Pilot Bearing Wear Sleeve against the input
shaft and lightly tap with a soft-faced hammer to start
installation.
CAUTION: Keep fingers clear to avoid personal injury.
6. Use the Wear Sleeve Driver (RR1061TR-2) to fully seat
the Pilot Bearing Wear Sleeve onto the input shaft.
7. Inspect the Pilot Bearing Wear Sleeve to ensure it is
fully seated on the input shaft.
NOTICE: If there is a gap between the Pilot Bearing
Wear Sleeve and the input shaft, the Wear Sleeve
Alignment Pin may have moved out of the groove;
remove the Pilot Bearing Wear Sleeve and re-perform
assembly procedure.
8. Install a new Spiral Snap Ring onto the Snap Ring
Installer (RR1061TR-1).
To Next Page
Loading...
