Eaton Power Xpert C445 - Page 159

Chapter 7—Monitoring and Diagnostics
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 145
Active Warning, continued
8 Jam
9 PF Deviation
10 Voltage phase loss
11 Voltage unbalance
12 Frequency deviation fast
13 Frequency deviation slow
14 Under current
15 High power
16 Low power
17 Contactor failure
18 Starts limit exceeded
19 Overload
20 Stall
21 Phase rotation mismatch
22 PTC - See PTC State for details
23 Peak demand
24 Measurement Module warning
25 Real Time Clock requires setting (has not been set)
26 RTC Battery Low. Replacement is recommended
27 Device ambient temperature high
28 MM high ambient temperature
29 UI high ambient temperature
30 Option card high ambient temperature
31 Ground Fault Module high ambient temp
41 Ground Fault Module CT open
42 Ground Fault Module CT shorted
43 Ground Fault Module CT no cal
44 HRGF Pulse Detect
220… 220–232 are logic engine warnings
1000… 1000–1049 Logic User warnings
Table 61. Active Fault, Warning and
Inhibit Values(Continued)
Value Description
Active Inhibit
0 No inhibits
1 Incorrect configuration. See configuration inhibit reason
2 A soft reset is required
3 Backspin prevention
4 Under voltage restart timer active
5 Control voltage is low
6 Under voltage condition
7 Voltage unbalance
8 Starts per hour limit has been exceeded
9 Over voltage condition
10 ELC Hardware mismatch
11 Run Interlock input open
1000… 1000–1049 Logic User inhibits
Table 61. Active Fault, Warning and
Inhibit Values(Continued)
Value Description