Appendix C—Optional Communication Cards
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 277
Instance Attributes
Sr. No. Attribute ID Access Data Type Attribute Name Attribute Description
9 9 (0x9) Get/Set UINT Delay time for solenoid valve to open (in
10ms)
Delay time for solenoid valve to open (in 10ms)
10 10 (0xA) Get/Set UINT Delay time for solenoid valve to close (in
10ms)
Delay time for solenoid valve to close (in 10ms)
11 11 (0xB) Get/Set USINT Non energized state of solenoid valve Non energized state of solenoid valve
12 12 (0xC) Get USINT Present source of control Present source of control
13 13 (0xD) Get/Set USINT Base Control Module Local Source
Selector
Base Control Module Local Source Selector
14 14 (0xE) Get/Set USINT Base Control Module Remote Source
Selector
Base Control Module Remote Source Selector
15 15 (0xF) Get/Set USINT Base Control Module Local/Remote
Power up mode
Base Control Module Local/Remote Power up mode
16 16 (0x10) Get/Set USINT Base Control Module Feedback Signal
Source Selector
Base Control Module Feedback Signal Source Selector
17 17 (0x11) Get/Set USINT Base Control Module Field Wiring
Configuration Selector
Base Control Module Field Wiring Configuration Selector
18 18 (0x12) Get/Set USINT Measurement Module Wire Configuration Measurement Module Wire Configuration
19 19 (0x13) Get UINT C445 Q1 Output function select C445 Q1 Output function select
20 20 (0x14) Get USINT C445 Q2 Output function select C445 Q2 Output function select
21 21 (0x15) Get USINT C445 Q3 Output function select C445 Q3 Output function select
22 22 (0x16) Get/Set UINT C445 Latching Q3 Relay Reset Source
select
C445 Latching Q3 Relay Reset Source select
23 23 (0x17) Get/Set USINT Relay 3 Behavior Relay 3 Behavior
24 24 (0x18) Get/Set USINT Latching Relay Behavior at Power-down Latching Relay Behavior at Power-down
Table 106. Modbus Object—Class 0xA0 (160)
Class Services
Service
Code
Service Name
0x0E Get Attribute Single
Instance Services
Service
Code
Service Name
0x0E Get Attribute Single
0x10 Set Attribute Single
Class Attributes
Sr. No. Attribute ID Access Rule Data Type Name Attribute Description
1 1 (0x1) Get UINT Revision Revision of this object
2 2 (0x2) Get UINT Max Instance Maximum instance number of an object currently created
in this class level of the device.
3 3 (0x3) Get UINT Number of Instances Number of object instances currently created at this class
level of the device.
Table 105. Operation Mode Object—Class 0x9F (159), continued