Eaton Power Xpert C445 - Table 103. Dynamic Input Assembly Instance Parameters

Appendix C—Optional Communication Cards
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 275
C445 supports following parameters as a member of dynamic input assembly instance.
Table 103. Dynamic Input Assembly Instance Parameters
Value Parameter Name Description
0 Assembly Terminator D_IN_ASM_TERMINATOR
1 Packed Device status (See Control Supervisor Object) C445_DEVICE_STATUS
2 Motor Current Phase A - Scaled MOTOR_I_A_SCALED
3 Motor Current Phase B - Scaled MOTOR_I_B_SCALED
4 Motor Current Phase C - Scaled MOTOR_I_C_SCALED
5 Motor Current Average - Scaled MOTOR_I_AVE_SCALED
6 Line Voltage LL Phases AB LINE_V_LL_AB_RMS
7 Line Voltage LL Phases BC LINE_V_LL_BC_RMS
8 Line Voltage LL Phases CA LINE_V_LL_CA_RMS
9 Line Voltage LL Average LINE_V_LL_AVE_RMS
10 Total Watts for all three phases POWER_WATTS
11 Line V Unbalance Percent LINE_V_UNBALANCE_PERC
12 Motor Current Average Percent FLA MOTOR_I_AVE_PERCENT_FLA
13 Apparent Power Factor POWER_PF_APPARENT
14 GF High Resistance - RMS MOTOR_GF_I_HR_RMS
15 Line Frequency - Scaled LINE_FREQ
16 Thermal memory Percent STATUS_OVLD_THERMAL_MEM_PERCENT
17 Signal Status Bits STATUS_SIGNAL_BITS
18 Warning Status Bits STATUS_WARNING_BITS
19 BCM Digital Input Status LOGIC_INPUT_STATE_BITFIELD
Table 104. Motor Info Object—Class 0x9B (155)
Class Services
Service
Code Service Name
0x0E Get Attribute Single
Instance Services
Service
Code Service Name
0x0E Get Attribute Single
0x10 Set Attribute Single
Class Attributes
Sr. No. Attribute ID Access Rule Data Type Name Attribute Description
1 1 (0x1) Get UINT Revision Revision of this object
2 2 (0x2) Get UINT Max Instance Maximum instance number of an object currently created
in this class level of the device.
3 3 (0x3) Get UINT Number of Instances Number of object instances currently created at this class
level of the device.
Instance Attributes
Sr. No. Attribute ID Access Data Type Attribute Name Attribute Description
1 1 (0x1) Get/Set UINT Rated Voltage Motor rated voltage
2 2 (0x2) Get/Set UDINT Motor Rated Hp Motor1 (Scaled by 100) Motor Rated Hp Run1
3 3 (0x3) Get/Set UDINT Motor Rated Hp Motor2 (Scaled by 100) Motor Rated Hp Run2
4 4 (0x4) Get/Set UDINT Motor Rated Watts Motor1 Motor Rated Watts Run1