Chapter 4—System Configuration and Commissioning
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 49
Power Xpert inControl Commissioning Software Tool
There is a Power Xpert inControl User Manual that describes all the features of this
powerful Software Tool (publication MN040013EN). Below is information on using the
Start-Up Wizard in this Software Tool.
The Start-Up Wizard executes under the following conditions:
1. Each time a new C445 is added to a project and the parameters are accessed in the
offline mode
2. Each time the parameters for a C445 are accessed online for the first time or if they
are accessed again without having been saved, then opened the saved
configuration file for the C445.
The wizard consists of 2 pages of parameters for single motor applications and 3 pages of
parameters for two motor applications. The two pages of parameters for single motor
applications are shown below:
If changes are made to any parameters on this page and the user does not need to view
the second page, select the check mark to save the changes made on this page and exit
the wizard.
If changes are made to any parameters on this page, or not, selecting the right arrow
button will save those changes and progress to the second page shown below.
At any time, there is a Close button located at the bottom right of each wizard screen (not
shown above). If that is selected no changes are saved and you will Exit the wizard.
Note: When a wizard opens on an online C445 DTM, the parameters contained in the
wizard are read from the C445.
To Next Page
Loading...
