Eaton Power Xpert C445 - C445 UM Monitoring; Figure 121. C445 UM Monitoring Menus; Figure 122. Monitoring Menu Data

Chapter 8—C445UM Monitoring User Interface
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 149
C445UM Monitoring
Five monitoring menus provide easy access to critical
system data.
I: Current Monitoring
V: Voltage Monitoring
P: Power Monitoring
T: Thermal Monitoring
O: Other System Monitoring
Figure 121. C445UM Monitoring Menus
Figure 122. Monitoring Menu Data
Data in
menu
toUse
scroll
Monitoring Menus: Press <MODE/BACK> to toggle through
I (Current)
Avg Current (Iavg)
Iavg % of FLA (I%FLA)
Current Unbalance (IUnb)
Ground Fault Current (IGF)
I Phase A (IA)
I Phase B (IB)
I Phase C (IC)
V (Voltage)
Avg Voltage(Vavg)
Voltage Unbalance (VUnb)
Phase Order (Ph Ord)
Voltage L1-L2 (L1-L2)
Voltage L2-L3 (L2-L3)
Voltage L3-L1 (L3-L1)
P (Power)
Watts Total (P Watts)
Power Factor (PF)
VA Total (P VA)
VARs Total (P VARS)
Real Energy* (P kWh)
T (Thermal)
Thermal Memory % (TM%)
Time to Reset (T to Rst)
Thermal Capacity % (TC%)
PTC state (PTC)
O (Other)
Run Time* (Run Time)
# Motor Starts (#Starts)
Max. Starting I (MaxStart)
Last Start Time (LastStart)
Frequency (Freq)
RTC Time (RTC Time)
IP Address (IP Addr)
Operating Time* (Op Time)
Contactor Ops Last Hr (Ctr Ops)
Speed RPM (Speed)
*Resettable parameter—Users can reset to zero in PRG menu.