Eaton Power Xpert C445 - Page 367

Appendix D—Modbus Register Map
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 353
1000 Trip Enable BYTE RW NV
Array size: 4
Default: 0x38, 0x00, 0x04,
0x00
Bitfield
Config CRC
Run Lock
Admin Lock
USB Lock
Backup Mem
Enable protections by selecting the box next to each protection to place a
check mark in it. Each protection selected will enable those protections
that the C445 will trip on, continued.
1002 Warning Enable BYTE RW NV
Array size: 4
Default: 0
Bitfield
Config CRC
Admin Lock
USB Lock
Backup Mem
Any Warnings needed for an application may be enabled by selecting the
box next to each to place a check mark in it. Each protection selected will
enable those protections the C445 will provide a warning for when that
condition occurs.
Table 128. C445 Modbus Register Map, continued
Register Name Attribute Description
Bit Description Coil
16 Reserved 16001
17 Starts limit exceeded 16002
18 Overload 16003
19 Stall 16004
20 Phase rotation mismatch 16005
21 PTC 16006
22 Under voltage restart 16007
23 Peak demand 16008
24 HRGF pulse detection 16009
Bit Description Coil
0 Under voltage 16017
1 Over voltage 16018
2 Reserved 16019
3 Ground current warning 16020
4 Current phase loss 16021
5 Current unbalance 16022
6 Instantaneous over current 16023
7 Jam 16024
8 Power factor deviation 16025
9 Voltage phase loss 16026
10 Voltage unbalance 16027
11 Frequency deviation fast 16028
12 Frequency deviation slow 16029
13 Under current 16030
14 High power 16031
15 Low power 16032
16 Reserved 16033
17 Starts limit exceeded 16034
18 Overload 16035
19 Stall 16036
20 Phase rotation mismatch 16037
21 PTC 16038
22 Under voltage resta
rt 16039
23 Peak demand 16040
24 HRGF pulse detection 16041