Outgoing - in the message list:Ifanyredalarmsymbolcanbeseeninthiscolumn,thismeansthatalarms
with the priority 1..9 are still pending, the fault has not yet been rectified. Alarms and messages with priority
1..99 can only be acknowledged in the alarm list. If any yellow symbol can be seen in this column, this means
these are messages with the priority 9 and the messages do not yet have a send time stamp. Yellow symbols
are only displayed in the message list. The message receives a "send time stamp" if it has been rectified. The
message remains in the message list until 1000 entries is exceeded.
Node: Designation of the E*LDS component that has signalled the alarm (e.g. "Deep freeze room 2").
Error Item ID: Identification of the Item ID (e.g. location) of the alarm to be better able to assign and locate an
error.
Item ID:ItemIDdesignation(e.g.roompositionandtypeoftherefrigeratedcaseetc.)oftheE*LDS
component.
Address:Interface(e.g.CANbus/Modbussegment)/addressoftheE*LDScomponent.
Message:Errornumber,alarmormessagetextoftheE*LDScomponent.
Priority:Messagepriorityofthealarm(1..99)ormessage(0,10,20,..90).
The views of the two lists can be alternated by tapping the tabs in the bottom left area. The lists can be
paged through by tapping the up / down buttons. If the Refresh button is displayed in the right
navigation bar, this means that the respective list is currently being updated automatically. If the
message "Data retrieval delayed, please wait.." is displayed, it can be helpful to change back to the
main menu and call up the alarm / message list again.
To Next Page
Loading...
Need help?
General
