MINUTEMAN 320
32
REV 13.1:2020
i. Verify collapsibility of telescoping nose
ii. Verify Reach of telescoping nose
11. Connect synchronization rod
a. Cut threaded rod, as required
b. Adjust stroke of synch rod on bar feed
c. Verify axial shift synch switch adjustment, adjust as required
12. Cut lathe sheet metal
a. If additional machines are present review for consistent appearance
13. Verify lathe signals
a. Emergency stop from lathe
b. Emergency stop from bar feeder
c. Door signal
d. Torque stop
e. Bar change
f. Auto cycle/cycle start
g. Collet open/close
14. Perform auto bar change with lathe
a. Add bar change program to lathe
15. Add oil to bar feeder
a. Verify oil off and on position
To Next Page
Loading...
