Efka AB620A5035 - Page 92

- AB620A5035 Instruction Manual
- 92 -
63 = Lockstitch: Juki DNU 1541-7
»Slide-in strips for V810/V820 =5/2«
64 = No function
65 = Chainstitch: Sagitta
»Slide-in strips for V810/V820 =5/2«
66 = Chainstitch: Strobel VTD 410EV
»Slide-in strips for V810/V820 =5/2«
67 = Chainstitch: Hengtai MP500»Slide-in strips for V810/V820
=5/2«
68 = Lockstitch: Typical/Mauser Klasse 333
»Slide-in strips for V810/820 =5/2«
69 = Lockstitch: Juki class 1760
»Slide-in strips for V810/820 =5/2«
70= Reserved
71= No function
72= CL205/CL204
»Slide-in strips for V810/820 =5/5«
73= Reserved
74= Chainstitch: Yamato VG
»Slide-in strips for V810/820 =5/5«
75= SHDA CL160-30
»Slide-in strips for V810/820 =5/5«
76= Reserved
77= Reserved
78=Golden Wheel CSR88914
»Slide-in strips for V810/820 =5/5«
79 Gute GT8700C
»Slide-in strips for V810/820 =5/5«
Other modes are selectable, however have the same functions as
mode 0.
291 810
Select slide-in strip number for the V810 control panel
(illustration see instruction manual for part V810/V820.
At setting 0, keys 1…4 are disabled.
13
0
1
292 820
Select slide-in strip number for the V820 control panel
(illustration see instruction manual for part V810/V820.
At setting 0, keys 1…0 are disabled.
17
0
1
293 tF1
Selection of the input function using key (A) “F1” on the
V810/V820 control panel
0 = Key F1 is disabled
1 = Needle up/down
2 = Needle up
3 = Single stitch (basting stitch)
4 = Full stitch
5 = Needle to position 2
6...12 = No function
13 = High lift for walking foot with speed limitation n10
(operational mode not stored)
14 = High lift for walking foot with speed limitation n10
(operational mode stored)
15 = Tape cutter / fast scissors (in chainstitch and
overlock mode)
16 = Intermediate backtack/intermediate stitch
condensing
17 = Stitch regulator suppression / recall
18 = No function
19 = Bobbin thread monitor
20..Rest = No function
100
0
17