56
Chapter 3 Conguring from a Web Browser
3. Drag a camera name and drop it on the position number where you want to display it.
The display positions of the source and destination camera images are switched.
e.g.) 4 screen layout
1. Drag display position 1 on Page 1 and drop it at display position 5 on page 2.
2. The display position 1 and display position 5 cameras are switched.
3. Only the camera name in the inner square is moved, without moving the display position of the
camera image.
4. Select “Apply”. The display positions of camera images are updated.
When you select “Reset”, the information of the setting being changed is discarded, and becomes the
current monitor display settings.
Note
• A camera web page link is embedded in frames that have been allocated a camera name. When you click
it, a camera web page will open in a separate window.
●
Other Display Settings
Set the items to be displayed in camera images.
Procedure
1. Select “Other Display Settings”.
The “Other Display Settings” screen is displayed.
2. Congure the items.
Item Detail Setting range
Camera Name Display Select to display or hide the camera name set on the
monitor. (The camera name is displayed on the upper left
of the image.)
On / Off
Sequence Interval Set the interval for changing over the screen during
sequential display.
5 to 60 seconds
Aspect Ratio Mode Set which aspect ratio to apply when the aspect ratio of the
video delivered from the network camera and the aspect
ratio of the monitor image display area differ.
If “Aspect” is selected when “Custom Screen” is selected
for the “Image Layout” (page 58), you can select either
“Full” or “Aspect” for each camera image.
Full / Aspect
3. Select “Apply”.
The setting complete screen is displayed. Select “OK”.
To Next Page
Loading...
