Eizo DuraVision FDF4627W-IP

63
Chapter 3 Conguring from a Web Browser
●
Communication Settings
The communication settings are used to congure the web interface function, detection of
communication errors, and so on.
1. In “System”, select “Communication Settings”.
The “Communication Settings” screen is displayed.
2. Congure the items.
Item Detail Setting range
Communication
Speed
Set the communication speed between the monitor and
network hub.
100Mbps Half duplex
/
100Mbps Full duplex
/
1000Mbps Full duplex
Communication Error
Detection
You can set the following as the message to be displayed
when receipt of image data stops.
Communication Error Detection On:
Within several seconds after receipt of image data stops,
an alert message in a red box will appear on the live image
screen. When communication resumes, the alert is cleared
and the image is displayed again.
Communication Error Detection Off:
When approx. 20 seconds have elapsed after receipt of
image data stops, a communication error message will
appear.
On / Off
Web Interface You can operate and congure the monitor from your web
browser over the network.
On / Off
*1
Web Interface Port Sets the port of the web interface
*2
1 to 65535
AUTH Method Sets the authentication method for the web interface.
*2
Digest authentication /
BASIC authentication
*1 The web interface cannot be set to Off if USB lock (page 64) and Remote lock (page 64) are set
to On.
*2 Can be specied when the web interface is set to On.
3. Select “Apply”.
The setting complete screen is displayed. Select “OK”.
Attention
• When the web interface is disabled, you will not be able to congure the monitor settings from your web
browser. When the web interface is disabled and “Apply” is selected, the following warning message
appears.